FIXED - Belt slips off pulley | Applianceblog Repair Forums
14-03-2014· The belt keeps falling off of the pulley. I keep putting it back on, and making sure it's in the right place on the drum, but when I turn the drum by hand, the belt slips off of the pulley. I notice the pulley surface is slightly convex toward the edges (like a donut) rather than flat like a...How To Fix A Dryer Making Noise – Dryer Repair,This part supplies tension on the drum belt to keep the belt from slipping on the drive motor pulley or the drum when your dryer’s spinning a load. The pulley spins quickly, so the friction here can wear it out. You can check by unplugging the dryer, taking off the lower access panel or the front panel, and finding the idler pulley and its shaft, usually at the base next to the drive motor. Remove the belt.what causes new drum belt to keep slipping off drum.new,,The rest is done by feel only; force the idler to the extreme right with one hand & while holding it there slip the belt on the motor pulley. Slowly let the idler go back down until it rest against the belt, now slowly rotate the drum counter clockwise with both hands on the outer rim, be careful of sharp metal edges in the process, to align the belt around the drum.